ADAPTABLE LIGHTING RANGES 

FLEXIBILITY IS ESSENTIAL TO YOUR NEEDS - We've built a lighting system that enables our harnesses to quickly and easily adapt from working as a single source of lighting to working in most any combination of lighting with HMI, Tungsten or HID's and Hybrids thereof.

HMI Adapters and turnarounds enable a wide range of lighting solutions from a 200W - 400W - 575W - 1.2K - 1.8K - 2.5K & 4K all via our Power Gems Flicker / Dimmable Ballast.

Small to Medium Lighting Balloons offer a custom 4K Tungsten Adapter outfitted with either 1K, 2K, 3K or 4K per circuit; in our medium to larger units we offer our 6K Adapters (650W Tungsten lamps are available to work in place of 1K's lamps). Standard 2.5K & 5K 220V Tungsten's are available as well - Tungsten lamps require 220V power. 

                      Let us know what your needs are, call us at 805.433.2200 or email: [email protected] 
​

INTERNAL GEL KITS

The success of our original Internal Gel Kit  allowed us to go far beyond the realm of traditional "hybrid" lighting.
Design updates have improved our set up time with greater efficiency and will work with both helium or air filled lights.
Outfitted Internal Gel Kit match up perfectly with those lights on the ground utilzing the same gels. For more information you can review our "Products" page by clicking on the button below.    

RIGGING 

Sometimes the light can prove to be too much, which leads to some alternatives.....The SLIM Light to the left had 2 x 575W HMI's and was too bright with only 1 x 575W light on, dimmed all the way down, unit was inverted to work as a bounce in which we took advantage of the spill over and adjusted the angle as needed. Simply inverting this light to work the way it did the DP was able to open lighting up to any row of seats with the auditorium.

We welcome the opportunity to be part of your tech scouts and to provide options, each location be it interior or exterior presents its own challenges; attending these scouts allow us to be better prepared and to make some suggestions as to shapes, sizes and potential cost savings.

                            We look forward to hearing from you.